Once again Scott Here to see if I can’t help you understand the something else I have seen questions about in the 3D printing community. This Time around I’ll go over the G-code used By Chitu on their F mini control board and other custom made control boards used by Tronxy and several other companies now. This control board comes on the Tronxy X5SA, X5ST, X5S-E2, XY-3 and XY-2 to name a few.
PLEASE NOTE CHANGING THESE SETTING WILL change your printers behavior. Therefore I do not recommend changing settings yourself without understanding what each setting your adjusting does.
162490 Hits
99 Comments
Recent Comments
What you need to do to turn on heated bed is open notepad then type
m8027 t1
M8500
Then save file to SD card. Then go to file ri... Read More
Friday, 27 April 2018 14:16
So unlike marlin you can upload seperate commands instead of the whole file?
Friday, 27 April 2018 20:22
Yes your uploading g code to change setting not complete firmware
Friday, 27 April 2018 20:23
162490 Hits