Flashing Tronxy X5S Factory Control board USB Cable only

Ok so Scott here again, this time I decided to go ahead and take things to a simple level based off a write up done by Syed Muhammad Shaheryar. I have seen so many comments and issues with people flashing firmware to their factory TronXY X5S control board, now this should work for flashing the firmware on the X3S as well but the firmware I included will need some edit work unlike for the X5S. This Version of Arduino IDE will work just like any other but it can be installed on a thumb drive or SD card  and moved from one computer to the next without having to install anything on that computer. it should also work on other boards but I have not tested it.

Continue reading
  5996 Hits
  47 Comments
Recent Comments
Scott Worthington
By doing it this way You can copy the same file onto a thumb drive and run off ant windows computer. and use to flash other boards... Read More
Saturday, 24 February 2018 01:52
Scott Worthington
If you do not fallow it step by step this might happen. If you had arduino installed before you must remove it first as this versi... Read More
Tuesday, 06 March 2018 19:23
Scott Worthington
While I have seen this work on Windows 10 I have also seen it be an issue if you have another Windows 7 computer I would try that.... Read More
Tuesday, 06 March 2018 19:32
5996 Hits
47 Comments

Tronxy X5S Build

What’s in the box?

 

Continue reading
  5603 Hits
  1 Comment
5603 Hits
1 Comment

To keep the site live and make improvements Please consider Donating. Thank you for your donation.