Ok so Scott here again lately I have been seeing a lot of post and comments about the factory Tronxy hotend so I figured I would go ahead and write up a quick tech article. While this is not the only way to rebuild or assemble the hotend assembly this is the way I do it. This also works on the E3D hotends I have but the throat is different on them. So let’s start with a few tools.
34838 Hits
4 Comments
Recent Comments
this part of the site does not have a upload options. the forum does.
Thursday, 15 February 2018 22:53
Normally I start out tightening it before it's cold then heat it up and check make sure it did not change.
Wednesday, 23 January 2019 20:01
34838 Hits