What's New In The 3D Printer World

        Once again Scott Here to see if I can’t help you understand the something else I have seen questions about in the 3D printing community.  This Time around I’ll go over the G-code used By Chitu on their F mini control board and other custom made control boards used by Tronxy and several other companies now. This control board comes on the Tronxy X5SA, X5ST, X5S-E2, XY-3 and XY-2 to name a few.
 
PLEASE NOTE CHANGING THESE SETTING WILL change your printers behavior. Therefore I do not recommend changing settings yourself without understanding what each setting your adjusting does.

          OK Scott Here again like normal. This time I had a little help from Norman Gilman with some pictures and a few of the steps, helping to get my mind in gear to write this. Now please note Neither Norman Or I installed these setup with the auto bed leveling because we use glass beds to thick for the factory blue sensor to see the bed through the glass.